Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › SUN GEAR AND ONE-WAY CLUTCH

SUN GEAR AND ONE-WAY CLUTCH > REASSEMBLY

for Preparation Click here



1. INSTALL SUN GEAR INPUT DRUM SHAFT SNAP RING


    AT08182
  1. Using screwdriver, install the snap ring.



2. INSTALL SUN GEAR INPUT DRUM


    AT08181
  1. Place a wooden block or similar object as a work stand, and place the planetary sun gear onto it.

  1. Install the sun gear input drum onto the planetary sun gear.



    AT07897
  1. Using a snap ring expander, install the snap ring.



3. INSTALL SUN GEAR SHAFT OIL SEAL RING


    AT08189
  1. Coat the 2 oil seal rings with ATF.

  1. Install the 2 oil seal rings onto the planetary sun gear.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.



4. INSTALL 1 WAY CLUTCH THRUST WASHER NO.1


    AT01642
  1. Install the 1 way clutch thrust washer No.1.

    HINT:
    Make sure that the lug shapes fit into the holes in the sun gear input drum.



5. INSTALL 1 WAY CLUTCH ASSEMBLY


    AT01643E02
  1. Install the 1 way clutch assembly onto the planetary sun gear.



6. INSPECT 1 WAY CLUTCH ASSEMBLY


    AT08440E02
  1. Hold the planetary sun gear, and turn the 2nd brake hub. Check that the 2nd brake hub can be turned freely clockwise and locked counterclockwise.