Home › TRANSMISSION ยท R351 MANUAL TRANSMISSION › INPUT SHAFT

INPUT SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL INPUT SHAFT FRONT BEARING


    D029020E01
  1. Using SST and a press, install a new input shaft front bearing onto the input shaft.

    SST
    09950-60010   (09951-00570)
    09950-70010   (09951-07100)

    NOTICE:
    Install the input shaft front bearing with the snap ring groove facing to the front.



2. INSTALL FRONT BEARING SHAFT SNAP RING


    D026115
  1. Select a front bearing snap ring so that the clearance between the input shaft and input shaft front bearing is within the specified values.

    Standard clearance:
    0.1 mm (0.0039 in.) or less
    Mark
    Thickness
    A
    2.10 to 2.15 mm (0.0827 to 0.0846 in.)
    B
    2.15 to 2.20 mm (0.0846 to 0.0866 in.)
    C
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    D
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    E
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)
    F
    2.35 to 2.40 mm (0.0925 to 0.0945 in.)
    G
    2.40 to 2.45 mm (0.0945 to 0.0965 in.)



3. INSTALL INPUT SHAFT BEARING


    D026114
  1. Apply gear oil to the input shaft bearing and install it onto the input shaft.



4. INSTALL SYNCHRONIZER RING NO.2


    D026113
  1. Apply gear oil to the synchronizer ring No.2, and install it onto the input shaft.