Home › TRANSMISSION ยท R351 MANUAL TRANSMISSION › COUNTER GEAR AND REVERSE IDLER GEAR

COUNTER GEAR AND REVERSE IDLER GEAR > INSPECTION

for Preparation Click here



1. INSPECT COUNTER GEAR


    C086509
  1. Using a micrometer, measure the outer diameter of the counter gear as shown in the illustration.

    Standard diameter:
    29.984 to 30.000 mm (1.1805 to 1.1811 in.)

    Minimum diameter:
    29.984 mm (1.1805 in.)

    If the outer diameter is less than the minimum, replace the counter gear with a new one.