Home › BODY ELECTRICAL › LIGHTING › CENTER ROOM LIGHT ASSEMBLY

CENTER ROOM LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT CENTER ROOM LIGHT ASSEMBLY (W/ PERSONAL LIGHT ASSEMBLY)


    B113721E01
  1. Remove the center room light assembly.

  1. Apply battery voltage to the center room light connector.

  1. Check that the center room light comes on.

    OK:

    Measurement condition
    Switch condition
    Specified condition
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 2
    DOOR
    Center room light comes on
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 1
    ON
    Center room light comes on

    If the result is not as specified, replace the center room light assembly.



2. INSPECT CENTER ROOM LIGHT ASSEMBLY (W/O PERSONAL LIGHT ASSEMBLY)


    B113720E01
  1. Remove the center room light assembly.

  1. Apply battery voltage to the center room light connector.

  1. Check that the center room light comes on.

    OK:

    Measurement condition
    Switch condition
    Specified condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Body ground
    ON
    Center room light comes on
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    DOOR
    Center room light comes on

    If the result is not as specified, replace the center room light assembly.

    NOTICE:
    Check that the ground wire of the center room light assembly is connected to body ground.