Home › BODY ELECTRICAL › LIGHTING › REAR FOG LIGHT SWITCH

REAR FOG LIGHT SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR FOG LIGHT SWITCH


    B113716
  1. Disconnect the connector from the rear fog light switch.

  1. Measure the resistance and voltage between the wire harness side connector and body ground.

    Resistance:

    Tester connection
    Condition
    Specified condition
    1- Body ground
    Always
    Below 1 Ω
    6- Body ground
    Headlight dimmer switch OFF → HEAD
    10 kΩ or higher → Below 1 Ω
    7- Body ground
    Front fog light switch OFF → ON
    10 kΩ or higher → Below 1 Ω
    8- Body ground
    Always
    Below 1 Ω


    Voltage:

    Tester connection
    Condition
    Specified condition
    3- Body ground
    Headlight dimmer switch OFF → TAIL
    Below 1 Ω → 10 to 14 V
    4- Body ground
    Always
    10 to 14 V

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. Reconnect the connector to the rear fog light switch.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:

    Tester connection
    Condition
    Specified condition
    8- Body ground
    Headlight dimmer switch OFF
    Below 1 V
    8- Body ground
    Headlight dimmer switch HEAD, rear fog light switch ON
    10 to 14 V
    8- Body ground
    Headlight dimmer switch OFF
    Below 1 V
    8- Body ground
    Headlight dimmer switch TAIL, front fog light switch ON, rear fog light switch ON
    10 to 14 V

    If the result is not as specified, replace the rear fog light switch.