Home › BODY ELECTRICAL › AUDIO / VISUAL › ROOF SPEAKER

ROOF SPEAKER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ROOF SPEAKER

HINT:
Remove interior parts so that the roof speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the roof speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the roof speaker.

  1. Speaker resistance check

    1. Disconnect the roof speaker connector.

    2. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Approximately 6 Ω

      If the result is not as specified, replace the roof speaker.