Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE WARNING INDICATOR

CLEARANCE WARNING INDICATOR > INSPECTION



1. INSPECT CLEARANCE WARNING INDICATOR


  1. Indicator check



      E104293E02
    1. Connect the positive battery terminal to connector terminal 7 (BD), and the negative battery terminal to terminal 1 (E).



    2. E104312E02
    3. When the negative battery terminal is connected to each terminal of the connector as shown in the table, check that the corresponding LED comes on.

      Standard:
      The corresponding LED comes on

      Terminal 
      LED
      Terminal to which negative battery terminal is connected
      Power indicator
      OP
      Back sonar
      BK
      Right front clearance sonar
      FR
      Left front clearance sonar
      FL
      Right rear clearance sonar
      RR
      Left rear clearance sonar
      RL
      If the result is not as specified, replace the clearance warning indicator.



  1. Back and clearance sonar buzzer operation check



      E104293E02
    1. Connect the positive battery terminal to connector terminal 7 (BD), and the negative battery terminal to terminal 1 (E).



    2. E104312E04
    3. Connect the negative battery terminal to connector terminal 11 (BZ) and check the operation of the buzzer in the clearance warning indicator.

      Standard:
      Operating noise (clicking sounds) can be heard.

      If the result is not as specified, replace the clearance warning indicator.

      HINT:
      The clearance warning buzzer is separately excited, and will not sound unless an alternating voltage is applied.