Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER SWITCH (for Cooler)

REAR BLOWER SWITCH (for Cooler) > INSPECTION

for Preparation Click here



1. INSPECT COOLER CONTROL SWITCH
  1. Remove the cooler control switch and disconnect the connector.



    E103713
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Switch position
    Specified condition
    Each terminal
    OFF
    10 kΩ or higher
    4 - 8
    LO
    Below 1 Ω
    1 - 4 - 8
    LO - ME
    Below 1 Ω
    1 - 4 - 8
    ME
    Below 1 Ω
    1 - 4 - 6 - 8
    ME - HI
    Below 1 Ω
    4 - 6 - 8
    HI
    Below 1 Ω

    If the resistance value is not as specified, replace the cooler control switch.