Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › HEATER SWITCH (for Rear Heater)

HEATER SWITCH (for Rear Heater) > INSPECTION

for Preparation Click here



1. INSPECT HEATER SWITCH


E103711E01
  1. Remove the heater switch and disconnect the connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Switch position
    Specified condition
    1 (TAIL) - 2 (L1)
    Always
    Below 1 Ω
    3 (S+) - 4 (S-)
    OFF → ON
    10 kΩ or higher → Below 1 Ω
    6 (IND) - 5 (E)
    Always
    Below 1 Ω

    If the resistance value is not as specified, replace the heater switch.