Clutch Switch Circuit
Circuit diagnosis · Vehicles built from Dec 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
While depressing the clutch pedal, the clutch switch sends a signal to terminal 73 (CLSW)*1 or 47 (D)*2 of the ECM. The ECM cancels cruise control when terminal 73 (CLSW)*1 or 47 (D)*2 receives the signal.*1: for 1KD-FTV
*2: for 2TR-FE
WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. INSPECT CLUTCH SWITCH ASSEMBLY |
Remove the clutch switch assembly (Click here).
Inspect the clutch switch assembly (Click here).
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (CLUTCH SWITCH ASSEMBLY - ECM AND BATTERY) |
Disconnect the B54 clutch switch assembly connector.
Disconnect the D98*1 or B71*2 ECM connector.*1: for 1KD-FTV*2: for 2TR-FE
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
B54-1 - Body ground
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for 1KD-FTV Tester Connection
Condition
Specified Condition
B54-2 - D98-73 (CLSW)
Always
Below 1 Ω
B54-2 - Body ground
Always
10 kΩ or higher
for 2TR-FE Tester Connection
Condition
Specified Condition
B54-2 - B71-47 (D)
Always
Below 1 Ω
B54-2 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
