TEST MODE PROCEDURE
Troubleshooting · Vehicles built from Dec 2017
Versions by build date: Jan 2017 – Nov 2017 from Dec 2017
| TEST MODE (SIGNAL CHECK MODE) PROCEDURE |
- HINT:
- When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.
After the tire pressure warning ECU and receiver completes the signal check for each inspection item, the DTCs for systems that are determined to be normal will be cleared.
The DTCs for other inspection items may not be cleared when only a certain signal is inspected.
- When test mode (signal check mode) returns to normal mode, all the test mode (signal check mode) DTCs will be cleared.
- Operation of the tire pressure warning reset switch can be checked in test mode (signal check mode).
- During test mode (signal check mode), the system is not initialized by pushing the tire pressure warning reset switch. The circuit of the tire pressure warning reset switch can be inspected during this mode.
- When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.
- HINT:
-


- Every time the test mode (signal check mode) DTC clear conditions are satisfied, the tire pressure warning light illuminates for 1 second. Following this, the tire pressure warning light blinks at 0.125 second intervals.
Text in Illustration *a
0.125 sec.
*b
ON
*c
OFF
Press the tire pressure warning reset switch (C2198/98).
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 3 seconds or more to check the vehicle speed signal (C2191/91).
Wait for 1.5 minutes with the vehicle stopped, or drive the vehicle at a speed of 50 km/h (31 mph) or more for 1 minute (C2181/81 to C2185/85).
- HINT:
- The tire pressure warning valve and transmitters send signals to the tire pressure warning ECU and receiver once every 1.5 minutes while the vehicle is stopped and once every minute while driving.
Check that the tire pressure warning system test mode (signal check mode) DTCs are cleared.
Test Mode (Signal Check Mode) DTC
Test Signal
Test Mode (Signal Check Mode) DTC Clear Condition
C2181/81 to C2185/85
Transmitter Data
Data is received from the relevant transmitter which has a registered ID in the tire pressure warning ECU and receiver.
C2191/91
Vehicle Speed Signal
Vehicle speed of 20 km/h (12 mph) or more is detected for 3 seconds or more.
C2198/98
Tire Pressure Warning Reset Switch Signal
A signal is received indicating that the tire pressure warning reset switch is pressed.
Result
- HINT:
- After the signal check is completed, check for test mode (signal check mode) DTCs to confirm the system status.
Condition
Procedure
Test mode (signal check mode) DTC is output
Repair the faulty part and enter signal check mode again
Test mode (signal check mode) DTCs are cleared
No problem
End of test mode (signal check mode)
After completing the test mode (signal check mode), turn the ignition switch off and disconnect the GTS.
Test mode (signal check mode) DTCs
If a trouble code is displayed during the test mode (signal check mode) DTC check, check the diagnosis procedure listed for that code. For details of each code, refer to the links below.
DTC No.
Detection Item
Trouble Area
See page
C2181/81
Transmitter ID1 not Received
- Tire pressure warning valve and transmitter
- Tire pressure warning ECU and receiver
Click here
C2182/82
Transmitter ID2 not Received
- Tire pressure warning valve and transmitter
- Tire pressure warning ECU and receiver
Click here
C2183/83
Transmitter ID3 not Received
- Tire pressure warning valve and transmitter
- Tire pressure warning ECU and receiver
Click here
C2184/85
Transmitter ID4 not Received
- Tire pressure warning valve and transmitter
- Tire pressure warning ECU and receiver
Click here
C2185/85
Transmitter ID5 not Received
- Tire pressure warning valve and transmitter
- Tire pressure warning ECU and receiver
Click here
C2191/91
Vehicle Speed Signal Error
- Meter / gauge system (speed signal)
- Vehicle speed signal circuit
- Wire harness or connector
- Tire pressure warning ECU and receiver
Click here
C2198/98
Initialization Switch
- Tire pressure warning reset switch
- Wire harness or connector
- Tire pressure warning ECU and receiver
Click here
- Tire pressure warning valve and transmitter