2014-2019 Hiace · Service Manual SUSPENSION & AXLE

C2111/11 Transmitter ID1 Operation Stop

Diagnostic trouble codes · Vehicles built from Dec 2017

Also covers:

Versions by build date: Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressures. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured air pressure values with the air pressure threshold. When the measured air pressure value is less than this threshold, the warning light in the combination meter illuminates. The tire pressure warning ECU and receiver stores a DTC when the tire pressure warning valve and transmitter stops transmitting signals. The signals can be forcibly transmitted by releasing the tire pressure rapidly. The stored DTC is cleared when signal transmission resumes.
DTC No.
DTC Detection Condition
Trouble Area
C2111/11
C2112/12
C2113/13
C2114/14
C2115/15
Tire pressure warning valve and transmitters stop transmitting signals
  1. Tire pressure warning valve and transmitter
  2. Tire pressure warning ECU and receiver

HINT:
It is necessary to perform the following procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.


WIRING DIAGRAM

C370426E01

INSPECTION PROCEDURE


1. PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS
  1. Set the tire pressure to the specified value (Click here).

  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  1. Check the values by referring to the table below.

    Tire Pressure Monitor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ID 1 Tire Inflation Pressure
    ID1 tire inflation pressure/
    min.: Absolute pressure (abs)/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (gauge)/ 0 kPa (0 kgf/cm2, 0 psi)
    max.: Absolute pressure (abs)/ 900 kPa (9.2 kgf/cm2, 131 psi), Relative pressure (gauge)/ 800 kPa (8.2 kgf/cm2, 116 psi)
    Actual tire inflation pressure
    If N/A is displayed, data has not been received.*
    ID 2 Tire Inflation Pressure
    ID2 tire inflation pressure/
    min.: Absolute pressure (abs)/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (gauge)/ 0 kPa (0 kgf/cm2, 0 psi)
    max.: Absolute pressure (abs)/ 900 kPa (9.2 kgf/cm2, 131 psi), Relative pressure (gauge)/ 800 kPa (8.2 kgf/cm2, 116 psi)
    Actual tire inflation pressure
    If N/A is displayed, data has not been received.*
    ID 3 Tire Inflation Pressure
    ID3 tire inflation pressure/
    min.: Absolute pressure (abs)/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (gauge)/ 0 kPa (0 kgf/cm2, 0 psi)
    max.: Absolute pressure (abs)/ 900 kPa (9.2 kgf/cm2, 131 psi), Relative pressure (gauge)/ 800 kPa (8.2 kgf/cm2, 116 psi)
    Actual tire inflation pressure
    If N/A is displayed, data has not been received.*
    ID 4 Tire Inflation Pressure
    ID4 tire inflation pressure/
    min.: Absolute pressure (abs)/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (gauge)/ 0 kPa (0 kgf/cm2, 0 psi)
    max.: Absolute pressure (abs)/ 900 kPa (9.2 kgf/cm2, 131 psi), Relative pressure (gauge)/ 800 kPa (8.2 kgf/cm2, 116 psi)
    Actual tire inflation pressure
    If N/A is displayed, data has not been received.*
    ID 5 Tire Inflation Pressure
    ID5 tire inflation pressure/
    min.: Absolute pressure (abs)/ 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (gauge)/ 0 kPa (0 kgf/cm2, 0 psi)
    max.: Absolute pressure (abs)/ 900 kPa (9.2 kgf/cm2, 131 psi), Relative pressure (gauge)/ 800 kPa (8.2 kgf/cm2, 116 psi)
    Actual tire inflation pressure
    If N/A is displayed, data has not been received.*

    HINT:
    1. *: It may take a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 (Click here).
    2. The wheel position cannot be determined from ID1 through ID5 on the Data List.

  1. Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.

    1. Check that each tire pressure data displayed on the GTS has changed.

      OK:
      Each tire pressure data displayed on the GTS will change to the value of the tire pressure.

      NOTICE:
      1. It may take a few minutes to display the updated tire pressure data.
      2. When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.

    2. After confirming that all of the tire pressure data displayed on the GTS has changed, set the tire pressure to the appropriate specified values.

      HINT:
      If the tire pressure data displayed on the GTS has not changed after rechecking, inspect for another problem (Click here).



NG
GO TO TRANSMITTER AND RECEIVER INSPECTION PROCEDURE (Click here)
OK

END


← C2111/11 Transmitter ID1 Operation Stop (+ C2112/12, C2113/13, C2114/14, C2115/15) (Jan 2017 – Nov 2017)C2121/21 No Signal from Transmitter ID1 (+ 9 more codes) (Jan 2017 – Nov 2017) →