2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Dec 2017

Versions by build date: Oct 2014 – Mar 2016 Apr 2016 – Nov 2017 from Dec 2017


1. REMOVE MANUAL TRANSMISSION ASSEMBLY
(Click here)

2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY

  1. C104155E01
    Remove the clutch release fork with the clutch release bearing from the transmission unit.

  1. Remove the release bearing and clip from the clutch release fork.


3. REMOVE CLUTCH RELEASE FORK DUST SEAL

  1. C389079E02
    Remove the clutch release fork collar from the clutch release fork sub-assembly.

  1. Remove the clutch release fork dust seal from the clutch release fork sub-assembly.


4. REMOVE CLUTCH RELEASE FORK BOOT

  1. C086354
    Remove the clutch release fork boot from the transmission unit.


5. REMOVE RELEASE FORK SUPPORT

  1. C086353J01
    Remove the release fork support from the transmission unit.


6. REMOVE CLUTCH COVER ASSEMBLY

  1. C114267E01
    Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the set bolts, and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.


7. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.


8. INSPECT INPUT SHAFT BEARING

  1. Q002481
    Turn the bearing by hand while applying force in the direction of the rotation.
    If the bearing is stuck or difficult to turn, replace the input shaft bearing.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.


9. REMOVE INPUT SHAFT BEARING

  1. C103897E01
    Remove 2 bolts at symmetrically opposite points.

  1. Using SST, remove the input shaft bearing.

    SST
    09303-35011  

← REMOVAL (Apr 2016 – Nov 2017)INSPECTION (from Oct 2014) →