2014-2019 Hiace · Service Manual ENGINE

Power Source Mode does not Change to ON (ACC)

Circuit diagnosis · Vehicles built from Dec 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode.

HINT:
When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

Related Data List and Active Test Items 
Problem Symptom
Data List Item
Active Test Item
Power source mode does not change to on (ACC) but does change to on (IG)
Power Source Control
  1. Power Supply Condition
  2. ACC Relay Monitor
-

WIRING DIAGRAM

Refer to DTC B2274 (Click here)

INSPECTION PROCEDURE

NOTICE:
  1. When using the GTS with the vehicle engine switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  2. The smart entry and start system (for Start Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the smart entry and start system (for Start Function) after confirming that the communication systems are functioning properly.
  3. Make sure that no DTCs are output. If any DTCs are output, proceed to the Diagnostic Trouble Code Chart (Click here).
  4. If the smart entry and start system is disabled through the customize function, enable the system before performing troubleshooting (Click here).
  5. Before replacing the certification ECU (smart key ECU assembly), refer to the smart entry and start system (for Start Function) precaution (Click here).
  6. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  7. After completing repairs, confirm that the problem does not occur.


1. CHECK FOR DTC


B
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
A


2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - NO. 2 INTEGRATION RELAY)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK NO. 2 INTEGRATION RELAY (ACC RELAY)


NG
REPLACE NO. 2 INTEGRATION RELAY
OK


4. INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← Power Source Mode does not Change to ON (ACC) (Jan 2017 – Nov 2017)COMPONENTS (from Oct 2014) →