2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Dec 2017

Versions by build date: Oct 2014 – Nov 2017 from Dec 2017


1. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side. (Click here)


2. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side. (Click here)


3. REMOVE FRONT DOOR SCUFF PLATE RH

4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover sub-assembly.


5. REMOVE FAN & GENERATOR V BELT

  1. A415339E02
    Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


6. REMOVE TENSIONER PULLEY

NOTICE:
Perform the following procedure when it is necessary to replace the tensioner pulley.

  1. A245347
    Remove the bolt, dust seal, tensioner pulley.

← REMOVAL (Oct 2014 – Nov 2017)INSPECTION (from Oct 2014) →