DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1.
REMOVE GENERATOR WITH CLUTCH PULLEY |
 |
Remove the generator pulley cap.
- Install SST onto the pulley and vise as shown in the illustration.
- SST
- 09820-63020
Mount SST (A) in a vise.
- Turn SST (B) clockwise, and loosen the pulley.
Remove the pulley.
| 2.
REMOVE GENERATOR REAR END COVER |
 |
- Remove the 3 nuts and generator rear end cover.
| 3.
REMOVE TERMINAL INSULATOR |
 |
- Remove the terminal insulator.
| 4.
REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
 |
- Remove the 2 screws and generator brush holder assembly.
| 5.
REMOVE GENERATOR COIL ASSEMBLY |
 |
- Remove the 4 through bolts.
- Using SST, remove the generator coil.
- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
Remove the generator washer.
| 6.
REMOVE GENERATOR ROTOR ASSEMBLY |
 |
Remove the generator rotor from the drive end frame.
| 7.
CHECK GENERATOR DRIVE END FRAME BEARING |
 |
- Check that the bearing is not rough or worn. If necessary, replace the bearing.
| 8.
REMOVE GENERATOR DRIVE END FRAME BEARING |
 |
- Remove the 4 screws and bearing retainer.
- Using SST, tap out the bearing.
- SST
- 09950-60010
(09951-00250)
09950-70010
(09951-07100)