2014-2019 Hiace · Service Manual DRIVE LINE

ADJUSTMENT

Removal / installation · Vehicles built from Oct 2014


1. INSPECT AND ADJUST DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. Remove the differential filler plug and gasket.

  1. D025304E04
    Check that the oil surface is within 5 mm (0.20 in.) of the lowest position of the inner surface of the differential filler plug opening.

    NOTICE:
    1. Excessively large or small amounts of oil may cause trouble.
    2. After replacing oil, drive the vehicle and check the oil level.

    HINT:
    If necessary, fill the rear differential carrier with hypoid gear oil.

  1. Check for oil leakage when the oil level is low.

  1. Install the differential filler plug and a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


2. FILL DIFFERENTIAL OIL
  1. Remove the differential filler plug and gasket.

  1. Fill with oil.

    Oil grade:
    Toyota Genuine Differential Gear oil GL-5 or equivalent

    Recommended oil viscosity 
    Above -18°C (0°F)
    SAE 90
    Below -18°C (0°F)
    SAE 80W or 80W-90
    Standard differential oil capacity 
    Body Type
    Specified Condition
    Standard Body
    3.10 liters (3.28 US qts, 2.73 Imp. qts)
    Wide Body
    3.25 liters (3.43 US qts, 2.86 Imp. qts)

  1. Check the oil level.

  1. Install the differential filler plug with a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

    NOTICE:
    After replacing the oil, recheck the oil level after driving.

← PROBLEM SYMPTOMS TABLE (from Jan 2017)COMPONENTS (from Oct 2014) →