PRECAUTION
Precautions · Vehicles built from Oct 2014
| 1.IGNITION SWITCH EXPRESSION |
- HINT:
- The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
| Ignition Switch off |
LOCK |
Off (Lock) |
| Ignition Switch ACC |
ACC |
On (ACC) |
| Ignition Switch ON |
ON |
On (IG) |
| Engine Start |
START |
On (Start) |
| 2.Before disassembly, clean the outside of the differential assembly and remove any sand or mud to prevent it from entering the inside of the assembly during disassembly and installation. |
| 3.When removing a connected part made of light alloy such as a differential carrier cover, tap it off with a plastic hammer. Do not attempt to pry it off with a screwdriver. |
| 4.Always arrange disassembled parts in order and protect them from dust. |
| 5.Before installation, thoroughly clean and dry each part and then apply hypoid gear oil API GL-5 or equivalent to them. Do not use alkaline cleaner for aluminum or rubber parts and ring gear set bolts. Also, do not clean rubber parts such as O-rings or oil seals with white gasoline. |
| 6.Coat any sliding surface and rotating part with hypoid gear oil API GL-5 or equivalent. |
| 7.When holding a part with a vise, be sure to place an aluminum sheet between the part and vise. Do not put it directly in the vise. |
| 8.Do not damage the contact surfaces of the case. Such damage may cause oil leakage. |
| 9.Do not fill with oil immediately after installing sealed parts. Wait at least an hour. |
| 10.Damage to the surfaces being contact with an oil seal, O-ring or gasket may cause oil leakage. |
| 11.When press-fitting an oil seal, do not damage the oil seal lip or outside periphery. |
| 12.When replacing a bearing, replace the inner and outer races as a set. |