REMOVAL
Removal / installation · Vehicles built from Dec 2015
Versions by build date: Oct 2014 – Nov 2015 from Dec 2015
| 1. DRAIN MANUAL TRANSMISSION OIL |
Remove the filler plug and gasket.
Using a 10 mm hexagon socket wrench, remove the drain plug and gasket, and drain the oil.

Text in Illustration *1
Gasket
*2
Drain Plug
Using a 10 mm hexagon socket wrench, install the drain plug with a new gasket.
- Torque:
- 44 N*m{ 450 kgf*cm , 33 ft.*lbf }
| 2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Super Long Wheelbase) |
Put matchmarks on both flanges.

Remove the 4 nuts, bolts and washers.
- HINT:
- If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller with center bearing shaft assembly from the differential companion flange.
Remove the 2 bolts and center support bearing assembly No.1.

Remove the propeller with center bearing shaft assembly.
Insert SST in the transmission to prevent oil leakage.

- NOTICE:
- Do not damage the oil seal.
Use the following SST for the automatic transmission.
- SST
- 09325-40010
Use the following SST for the manual transmission.
- SST
- 09325-20010
| 3. REMOVE PROPELLER SHAFT ASSEMBLY (for Long Wheelbase) |
Put matchmarks on both flanges.

Remove the 4 nuts, bolts and washers.
- HINT:
- If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.
Remove the propeller shaft assembly.
Insert SST in the transmission to prevent oil leakage.

- NOTICE:
- Do not damage the oil seal.
Use the following SST for the automatic transmission
- SST
- 09325-40010
Use the following SST for the manual transmission
- SST
- 09325-20010
| 4. REMOVE MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL |
Using SST, remove the oil seal.

- SST
- 09308-00010
