2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C102206E01
    Put matchmarks on the control cable assembly and the outer lever.

  1. Remove the 2 nuts and separate the transmission control cable assembly from the outer lever.

  1. C102207
    Using a screwdriver, disengage the claws of the 2 clips.

  1. Remove the 2 clips and separate the transmission control cable assembly from the transmission control cable bracket No.1

  1. C102625
    Remove the bolt and control cable support.

  1. C102621
    Remove the bolt and separate the clamp.

  1. C102620
    Remove the 2 nuts and control cable bracket No.2.


3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER

  1. B365544
    Using a clip remover, remove the 2 clips.

  1. Detach the 4 clips and remove the instrument panel finish lower.

  1. Disconnect each connector.

  1. B102838
    Push the positions indicated by the arrows in the illustration to disconnect the fuel lid lock control cable and bonnet (hood) control cable assembly from the instrument panel finish lower.


4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

  1. B365546
    Using a clip remover, remove the 2 clips

  1. Detach the 3 claws and remove the instrument panel under cover sub-assembly No. 1.


5. REMOVE PARKING BRAKE HOLE COVER

  1. B365547
    Detach the 6 claws and remove the parking brake hole cover.

  1. Disconnect each connector.


6. REMOVE SHIFT LEVER KNOB

  1. B365548E01
    Turn the shift lever knob in the direction indicated by the arrow and remove it.
    Text in Illustration 
    *A
    for Manual Transmission
    *B
    for Automatic Transmission


7. REMOVE SHIFTING HOLE COVER ASSEMBLY

  1. B365550E01
    for Manual Transmission:
    Detach the 6 claws and remove the shifting hole cover assembly.
    Text in Illustration 
    *A
    for Manual Transmission
    *B
    for Automatic Transmission

  1. for Automatic Transmission:
    Detach the 8 claws and remove the shifting hole cover assembly.


8. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER

  1. B365551E01
    Detach the 8 claws and remove the instrument panel finish panel lower center.
    Text in Illustration 
    *A
    for Manual Transmission
    *B
    for Automatic Transmission


9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

  1. C114289
    Separate the control cable assembly from the shift lever.

  1. C114291E01
    Pull out the control cable assembly locks.

  1. Turn the adjust nut clockwise 180°. While holding the adjust nut, separate the control cable assembly.

  1. C112966
    Wide body LHD steering position type:

    1. Remove the 2 nuts and clamp.

  1. C102618
    Remove the 2 nuts and front floor footrest.

  1. C102619
    Remove the 2 bolts and transmission control cable assembly.

← COMPONENTS (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2014) →