2014-2019 Hiace · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY

  1. C102645
    Install the clutch accumulator assembly with the 2 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Using a union nut wrench, connect the 2 clutch tubes.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench (Click here).


2. ADD BRAKE FLUID

Fluid:
SAE J1703 or FMVSS No. 116 DOT3 or equivalent

NOTICE:
Do not remove the filter from the brake master cylinder reservoir and be sure to fill with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.


3. BLEED CLUTCH LINE
  1. Fill the brake reservoir tank with brake fluid and bleed the clutch system.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }


4. INSPECT FOR BRAKE FLUID LEAK

HINT:
Check for leakage in the clutch system.


5. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1703 or FMVSS No.116 DOT3 or equivalent

    NOTICE:
    Do not remove the filter from the brake master cylinder reservoir and be sure to fill with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.

← INSTALLATION (Oct 2014 – Mar 2016)INSTALLATION (from Jan 2017) →