2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF)
  1. Disconnect the exhaust gas temperature sensor connector and detach the clamp.

  1. Disconnect the No. 2 exhaust gas temperature sensor connector and detach the 2 clamps.

  1. Disconnect the No. 3 exhaust gas temperature sensor connector and detach the 2 clamps.

  1. A262923
    Disconnect the No. 1 exhaust pipe air hose and No. 7 exhaust pipe air hose from the front exhaust pipe.

  1. A239813
    Remove the 2 No. 4 exhaust pipe supports.

  1. Remove the 3 nuts and front exhaust pipe.

  1. Remove the gasket.


3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Set the shift lever to the neutral position.

  1. C101771E01
    Remove the nut from the control shaft lever.

  1. Remove the clip and disconnect the control cable from the control cable bracket.


4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

  1. C101787E01
    Disconnect the park/neutral position switch connector.

  1. C101516E03
    Using a screwdriver, pry out the lock washer.

  1. Remove the lock nut and lock washer.

  1. C080256
    Remove the bolt and park/neutral position switch.

    HINT:
    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →