2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2016 from Jan 2017


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY

  1. C101767
    Remove the transmission oil level gauge.


3. DRAIN AUTOMATIC TRANSMISSION FLUID

  1. C101769E01
    Remove the drain plug, gasket and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }


4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

  1. C101768E01
    Remove the 2 bolts and transmission oil filler tube.

  1. Remove the O-ring from the oil filler tube.


5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

  1. G022488
    Uniformly loosen the 19 bolts and remove the transmission oil pan sub-assembly.

  1. A120816
    Install the blade of a oil pan seal cutter between the transmission case and oil pan, cut off applied sealer and remove the oil pan.

    NOTICE:
    When removing the oil pan, be careful not to damage the oil pan flange.

  1. D029014E02
    Remove the 3 magnets from the oil pan.

  1. Examine particles in the pan.

    1. AT00103
      Collect any steel chips with the removed magnets. Carefully look at the foreign objects and particles in the pan and on the magnets to guess at the type of wear which might be found in the transmission. Steel (magnetic)... bearing, gear and clutch plate wear. Brass (non-magnetic)... bushing wear


6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

  1. G021841E01
    Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid will come out of the oil strainer.

  1. Remove the 3 gaskets from the oil strainer.


7. DISCONNECT TRANSMISSION WIRE

  1. w/o Flex Lock-up:
    Disconnect the 4 connectors.

    C364901E01

    Text in Illustration 
    *A
    w/ Flex Lock-up
    *B
    w/o Flex Lock-up
    *1
    ATF Temperature Sensor
    -
    -

  1. w/ Flex Lock-up:

    1. Disconnect the 4 connectors.

    2. Detach the ATF temperature sensor from the temperature sensor clamp.


8. REMOVE TRANSMISSION WIRE

  1. G022489
    Remove the bolt and pull out the transmission wire.

  1. C058095E01
    Remove the O-ring from the transmission wire.

← REMOVAL (Oct 2014 – Dec 2016)INSPECTION (Oct 2014 – Dec 2016) →