2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built Oct 2014 – Dec 2016

Versions by build date: Oct 2014 – Dec 2016 from Jan 2017


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY

  1. C101767
    Remove the ATF level gauge sub-assembly.


3. DRAIN AUTOMATIC TRANSMISSION FLUID

  1. C101769E01
    Remove the drain plug, the gasket , and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }


4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

  1. C101768E01
    Remove the 2 bolts and transmission oil filler tube sub-assembly.

  1. Remove the O-ring from the oil filler tube sub-assembly.


5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

  1. G022488
    Remove the 19 bolts and oil pan sub-assembly.

  1. Q007487E01
    Install the blade of SST between the transmission case and oil pan, cut off applied sealer and remove the oil pan.
    SST
    09032-00100  

    NOTICE:
    When removing the oil pan, be careful not to damage the oil pan flange.

  1. D029014E02
    Remove the 3 magnets from the oil pan.

  1. AT00103
    Examine particles in pan.

    1. Remove the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission. Steel (magnetic) ... bearing, gear and clutch plate wear Brass (non-magnetic) ... bushing wear


6. TEMPORARILY TIGHTEN VALVE BODY OIL STRAINER ASSEMBLY

  1. G021841E01
    Remove the 4 bolts and oil strainer.

  1. Remove the 3 gaskets from the oil strainer.


7. SEPARATE TRANSMISSION WIRE

  1. C058460
    Separate the ATF temperature sensor connector and shift solenoid valve connectors.


8. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

  1. D029011
    Remove the 20 bolts and valve body assembly.


9. REMOVE SHIFT SOLENOID VALVE

  1. D028710E01
    Remove the bolt and shift solenoid valve S1 and S2.

  1. Remove the bolt and shift solenoid valve SL.

  1. Remove the bolt, solenoid lock plate and shift solenoid valve SLT.

  1. Remove the O-rings from the shift solenoid valves (S1, S2, SL).

← COMPONENTS (from Jan 2017)REMOVAL (from Jan 2017) →