2014-2019 Hiace · Service Manual TRANSMISSION

ADJUSTMENT

Removal / installation · Vehicles built from Oct 2014


1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
  1. Apply the parking break and turn ignition switch on.

  1. Depress the break pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.

  1. Check that the back up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function.

  1. If a failure is found, check the park/neutral position switch for continuity.


2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

  1. C101839E01
    Move the shift lever to the N position.

  1. Loosen the bolt of the park/neutral position switch.

  1. Align the groove and the neutral basic line.

  1. Hold the switch in position and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }

  1. After adjustment, perform the inspection.

← INSPECTION (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2014) →