REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. DISCONNECT BATTERY NEGATIVE CABLE |
| 2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
Remove the nut and disconnect the control cable assembly from the control shaft lever.

Remove the clip and disconnect the control cable assembly.
| 3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Remove the 2 bolts and heat insulator assembly from the park/neutral position switch assembly.

Disconnect the connector from the park/neutral position switch assembly.

Using a screwdriver, pry out the tabs of nut stopper and remove the lock nut and nut stopper.

Remove the bolt and park/neutral position start switch assembly.

- HINT:
- Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.
