2014-2019 Hiace · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL TRANSMISSION WIRE

  1. G021842E01
    Coat the ATF to a new O-ring and install it to the transmission wire.

  1. G022489
    Install the transmission wire to the transmission assembly with a bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


2. CONNECT TRANSMISSION WIRE

  1. C058460
    Connect the ATF temperature sensor and 4 connector of transmission solenoid connectors to the transmission valve body.


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

  1. G021841E03
    Install 3 new gaskets to the oil strainer assembly.

  1. Install the oil strainer assembly to the transmission valve body with 4 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    Bolt length:

    Bolt A:
    14 mm (0.55 in.)
    Bolt B:
    20 mm (0.79 in.)
    Bolt C:
    23 mm (0.91 in.)


4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

  1. D029014E05
    Install the 3 magnets to the transmission oil pan.

  1. C058273E03
    Remove any FIPG material and be careful not to drop oil on the contacting surfaces of the transmission case and the oil pan.

    NOTICE:
    Apply seal packing to the contact surface and install the oil pan with in 10 minutes of application.

  1. Apply FIPG to the oil pan.

    FIPG:
    Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent

  1. G022488
    Uniformly tighten the 19 bolts in several times and install the transmission oil pan.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }


5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

  1. C102934E03
    Coat a new O-ring with ATF.

  1. Install the oil filler tube with 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 10 ft.*lbf }


6. CONNECT BATTERY NEGATIVE CABLE

7. ADD AUTOMATIC TRANSMISSION FLUID

8. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
Drive the vehicle so that the engine and transmission are at normal operating temperature.

Fluid temperature:
70 to 80 °C (158 to 176 °F)

  1. D025120E01
    Park the vehicle on a level surface and set the parking brake.

  1. With the engine idling and the brake pedal depressed, move shift the lever into all positions from P to L and return to the P position.

  1. Take out the dipstick and wipe it clean.

  1. Put it back all the way.

  1. Take it out again and check that the fluid level is within the HOT range.
    If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.


9. PERFORM INITIALIZATION
(Click here)
← INSTALLATION (Jan 2015 – Mar 2016)INSTALLATION (from Jan 2017) →