2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCONNECT BATTERY NEGATIVE CABLE

2. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY

  1. C102919
    Remove the transmission oil level gauge sub assembly from the transmission oil filler tube.


3. DRAIN AUTOMATIC TRANSMISSION FLUID

  1. C101769E04
    Drain the automatic transmission fluid and remove the drain plug and gasket.

  1. Install the drain plug with a new gasket.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }


4. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

  1. C102934E01
    Remove the oil filler tube with 2 bolts.

  1. Remove the O-ring from the oil filler tube.


5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

  1. G022488
    Uniformly loosen the 19 bolts and remove the transmission oil pan sub-assembly

  1. Q007487E04
    Insert oil pan seal cutter between the transmission case and oil pan. Cut through the seal and remove the oil pan.

    NOTICE:
    1. Be careful not to damage the oil pan and flange.
    2. Do not incline the oil pan because of any fluid will remain in the oil pan.

  1. D029014E06
    Remove the 3 magnet from the transmission oil pan.


6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

  1. G021841E06
    Remove the 4 bolts, oil strainer assembly and 3 gaskets.


7. SEPARATE TRANSMISSION WIRE

  1. C058460
    Disconnect the ATF temperature sensor and 4 transmission solenoid connectors from the transmission valve body.


8. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

  1. D029011
    Remove the 20 bolts.

  1. Remove the bolt and transmission solenoid assembly (SL1) and transmission solenoid assembly (SL2).

    C103256E01

  1. Remove the bolt and solenoid lock plate and shift control solenoid (SLU)t.

  1. Remove the bolt and solenoid lock plate and line pressure control solenoid assembly (SLT).

  1. Remove the 2 O-rings from the 2 transmission solenoid assemblies (SL1, SL2).

← COMPONENTS (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2014) →