2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE FRONT SEAT ASSEMBLY RH
(Click here)

2. REMOVE FRONT DOOR SCUFF PLATE RH

3. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover sub-assembly.


4. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and No. 1 engine under cover.


5. REMOVE FAN AND GENERATOR V BELT

  1. A102135E01
    Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the fan and generator V belt. Then remove the fan and generator V belt.

    NOTICE:
    When removing the fan and generator V belt, do not use the bolt of the idle pulley.

    HINT:
    After removing the fan and generator V belt, move the tensioner upward to the maximum amount.


6. REMOVE CRANKSHAFT PULLEY

  1. A101288E03
    Using SST, hold the crankshaft pulley and loosen the pulley bolt until 2 or 3 threads are screwed into the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  
    Text in Illustration 
    *a
    Loosen
    *b
    Hold

  1. A101289E04
    Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05010, 09954-05021)
    Text in Illustration 
    *a
    Turn
    *b
    Hold

    HINT:
    Apply lubricant to the threads and end of SST.


7. REMOVE FRONT CRANKSHAFT OIL SEAL

  1. A102144E02
    Using a screwdriver with its tip taped, pry out the front crankshaft oil seal.
    Text in Illustration 
    *a
    Protective Tape
    *b
    Cut Position

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

← COMPONENTS (from Oct 2014)INSTALLATION (from Oct 2014) →