INSTALLATION
Removal / installation · Vehicles built Oct 2014 – Nov 2017
Versions by build date: Oct 2014 – Nov 2017 from Dec 2017
| 1. INSTALL TENSIONER PULLEY |
- NOTICE:
- Perform the following procedure when it is necessary to replace the tensioner pulley.
- HINT:
- The tensioner pulley service kit consists of a bolt, dust seal and tensioner pulley.
Install the dust seal and bolt to the tensioner pulley as shown in the illustration.

Text in Illustration *1
Bolt
*2
Tensioner Pulley
*3
Dust Seal


Front
- NOTICE:
- The dust seal must be oriented correctly when installed. If the dust seal is installed incorrectly, the bearing may be damaged.
- Do not touch the seal surface of the bearing.
- The dust seal must be oriented correctly when installed. If the dust seal is installed incorrectly, the bearing may be damaged.
- HINT:
- Be sure to use the bolt from the service kit.
Tighten the bolt by hand until the flange of the bolt contacts the dust seal and the tensioner pulley is fixed in place.
- NOTICE:
- Do not use any tools.
Tighten the bolt.
- Torque:
- 50 N*m{ 510 kgf*cm , 37 ft.*lbf }
| 2. INSTALL FAN & GENERATOR V BELT |
![]() ![]() |
Install the drive belt to the pulleys except the drive belt tensioner pulley.
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.
- NOTICE:
- The backside of the drive belt should face the tensioner pulley.
- Check that the drive belt is properly set to each pulley.
- The backside of the drive belt should face the tensioner pulley.
After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.

| 3. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Install the engine service hole cover with the 5 bolts.
- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
| 4. INSTALL FRONT DOOR SCUFF PLATE RH |
| 5. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
Perform the same procedure as above on the opposite side. (Click here)
| 6. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
Perform the same procedure as above on the opposite side. (Click here)

