2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

2. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)
  1. Perform the same procedure as above on the opposite side. (Click here)


3. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)
  1. Perform the same procedure as above on the opposite side. (Click here)


4. REMOVE FRONT DOOR SCUFF PLATE RH

5. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the engine service hole sub cover assembly.


6. REMOVE FAN & GENERATOR V BELT

  1. A102808E03
    Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.


7. SET NO.1 CYLINDER TO TDC/ COMPRESSION

  1. A072847E01
    Align the matchmarks of the crankshaft pulley and timing gear case cover by rotating the crankshaft in clockwise direction.

    HINT:
    Make sure that both camnoses on the intake side and exhaust side of the cylinder No.1 face upward.


8. REMOVE TIMING BELT COVER NO.1
  1. Remove the wire harness clamp.

  1. A102815
    Remove the 6 bolts and timing belt cover No.1.


9. REMOVE TIMING BELT

  1. A070549E01
    Turn the crankshaft in the clockwise direction and align the timing marks as shown in the illustration.

  1. A070550
    Uniformly loosen the 2 bolts, and remove the chain tensioner assembly No.1.

  1. Remove the timing belt.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →