REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. DRAIN AUTOMATIC TRANSMISSION FLUID |
Drain the automatic transmission fluid and remove the drain plug and gasket.

Install the drain plug with a new gasket.
- Torque:
- 20 N*m{ 205 kgf*cm , 15 ft.*lbf }
| 2. REMOVE PROPELLER SHAFT ASSEMBLY |
Put matchmarks on both flanges.

Remove the 4 nuts, bolts and washers.
- HINT:
- If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.
Remove the propeller shaft assembly.
Insert SST in the transmission to prevent oil leakage.

- NOTICE:
- Do not damage the oil seal.
Use the following SST for the automatic transmission
- SST
- 09325-40010
Use the following SST for the manual transmission
- SST
- 09325-20010
| 3. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL |
Using SST, pull out the oil seal.

- SST
- 09308-00010
