2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine rpm of approximately 1,000 for 5 to 6 minutes to circulate the refrigerant and collect compressor oil remaining in each component into the cooler compressor as much as possible.

  1. Stop the engine.

  1. Using SST, let the refrigerant gas out.

    SST
    07110-58060   (07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)


2. REMOVE FRONT BUMPER COVER
(Click here)

3. REMOVE AIR CLEANER ASSEMBLY
(Click here)

4. DISCONNECT COOLER REFRIGERANT DISCHARGE PIPE A

  1. E103920
    Remove the bolt and disconnect the cooler refrigerant discharge pipe A.

  1. Remove the O-ring from the cooler refrigerant discharge pipe A.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


5. DISCONNECT COOLER REFRIGERANT DISCHARGE PIPE B

  1. E103921
    Remove the bolt and disconnect the cooler refrigerant discharge pipe B.

  1. Remove the O-ring from the cooler refrigerant discharge pipe B.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


6. DISCONNECT NO. 3 AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

  1. E103922
    Remove the bolt and disconnect the No. 3 air conditioning tube and accessory assembly.

  1. Remove the O-ring from the No. 3 air conditioning tube and accessory assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


7. REMOVE MAGNET VALVE

E253331
  1. Disconnect the connector.

  1. Remove the 2 nuts and magnet valve assembly.

  1. E255103
    Remove the 2 nuts, 2 bolts and bracket.

  1. E253330
    Detach the clamp.

  1. Remove the 3 bolts and magnet valve from the bracket.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →