2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL FUEL FILTER ELEMENT

  1. A102693E01
    Attach 2 new O-ring to a new fuel filter element sub-assembly and a new O-ring to the fuel filter case sub-assembly.

  1. Install the fuel filter element sub-assembly to fuel filter case sub-assembly.

  1. A102984
    Align the matchmark on fuel filter cap assembly with the 2 matchmarks on the fuel filter case sub-assembly.

  1. A102985E01
    Turn the fastener nut until a 'click' sound is heard.

    HINT:
    Just before the marks of the case and nut align, the turning difficulty of the fastener nut will increase. Use a screwdriver as a lever to turn the fastener nut.

  1. Install the fuel filter assembly.

  1. Install the 2 fuel hoses.

  1. Install the 2 fuel heater hoses. (w/ fuel heater)


2. INSTALL FUEL TANK CAP ASSEMBLY

3. CONNECT BATTERY NEGATIVE CABLE

4. RESET FUEL FILTER AND FILTER WARNING LAMP
  1. Turn the ignition switch on.

  1. A103400E01
    After turning the ignition switch on, connect the clogging sensor connector within 3 to 60 seconds.

  1. Check that the combination meter's filter warning light turns off.


5. BLEED FUEL LINE

  1. A114068E01
    Using the hand pump, bleed air from the fuel system until pumping becomes difficult.


6. PREFORM INITIALIZATION
(Click here)

7. CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch on.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Active Test.

    5. Perform the Active Test.

      Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected
      2. Above conditions preserved while test is ON

← INSTALLATION (Jan 2015 – Mar 2016)INSTALLATION (from Jan 2017) →