2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


FUEL PUMP
  1. Inspect the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω

      If the result is not as specified, replace the fuel pump.

  1. Inspect the operation of the fuel pump.

    1. A197423E02
      Connect the positive (+) lead of the battery to terminal 1 of the connector and the negative (-) lead to terminal 2. Check that the fuel pump operates.
      Text in Illustration 
      *a
      Component without harness connected
      (Fuel Pump)
      If the fuel pump does not operate, replace the fuel pump.

      NOTICE:
      1. This test must be performed within 10 seconds to prevent the coil from burning out.
      2. Keep the fuel pump as far away from the battery as possible.
      3. Always turn the voltage on and off at the battery, not the fuel pump.

← DISASSEMBLY (from Jan 2015)REASSEMBLY (Oct 2014 – Dec 2014) →