INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT FUEL PUMP |
Inspect the resistance.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
0.2 to 3.0 Ω
Inspect the operation of the fuel pump.
Connect the positive (+) lead of the battery to terminal 1 of the connector and the negative (-) lead to terminal 2. Check that the fuel pump operates.

If the fuel pump does not operate, replace the fuel pump.Text in Illustration *a
Component without harness connected
(Fuel Pump)
- NOTICE:
- This test must be performed within 10 seconds to prevent the coil from burning out.
- Keep the fuel pump as far away from the battery as possible.
- Always turn the voltage on and off at the battery, not the fuel pump.
- This test must be performed within 10 seconds to prevent the coil from burning out.
