INSTALLATION
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL EXHAUST PIPE ASSEMBLY TAIL |
Connect the exhaust pipe supports, and install the exhaust pipe assembly tail.
| 2. INSTALL EXHAUST PIPE SUB-ASSEMBLY FRONT NO.1 |
Install a new gasket and exhaust pipe sub-assembly front No.1 with the 3 bolts.
- Torque:
- 62 N*m{ 632 kgf*cm , 46 ft.*lbf }
Tighten the clamp bolt, and install the exhaust pipe support bracket No.1 to the exhaust pipe sub-assembly front No.1.
| 3. INSTALL EXHAUST PIPE SUB-ASSEMBLY FRONT NO.2 |
Inspect the compression spring.

Using vernier calipers, measure the free length of the compression springs.
- Minimum length:
- 40.5 mm (1.594 in.)
- HINT:
- If the free length is less than the minimum, replace the compression spring.
Install the gasket.

Fully insert a new gasket to the exhaust pipe sub-assembly front No.1 by hand.
Using a wooden block, uniformly strike the gasket so that the gasket and exhaust pipe sub-assembly front No.1 are properly fit.
- NOTICE:
- Be careful with the installation direction of the gasket.
- Do not damage the outer face.
- Do not reuse the gasket.
- To ensure a proper seal, do not use the exhaust pipe sub-assembly front No.2 to force the gasket onto the exhaust pipe sub-assembly front No.1.
- Be careful with the installation direction of the gasket.
Connect the exhaust pipe support, and install a new gasket and the exhaust pipe sub-assembly front No.2 with the 4 bolts, 2 nuts, and 2 compression springs.
- Torque:
- Exhaust pipe sub-assembly front No.1 side:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }
- Exhaust pipe assembly tail side:
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
- NOTICE:
- After installation, check that the clearance is almost same at any point between the flanges of the exhaust pipe sub-assembly front No.2 and exhaust pipe sub-assembly front No.1.
| 4. CHECK FOR EXHAUST GAS LEAKS |
