REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
|
 |
- Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever assembly.
Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
| 3.
REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET
|
 |
- Remove the 2 bolts and the No. 1 transmission control cable bracket from the automatic transmission housing.
| 4.
REMOVE STARTER ASSEMBLY |
 |
- for Wide Body:
Remove the bolt, then disconnect the ground cable.
- Open the terminal cap.
Remove the nut and disconnect the wire harness from terminal 30.
Disconnect the terminal 50 connector from the starter.
- for Automatic Transmission:
Remove the bolt and 2 nuts, then remove the starter.
- for Manual Transmission:
Remove the bolt and nut, then remove the starter.