2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Apr 2016

Versions by build date: Oct 2014 – Mar 2016 from Apr 2016


1. INSTALL GENERATOR ASSEMBLY

  1. A088507E01
    Install the generator assembly with the 3 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. Install the generator wire with the nut to terminal B.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Install the terminal cap.

  1. Connect the generator connector.


2. INSTALL FAN & GENERATOR V BELT

G035171E02
  1. Install the drive belt to the pulleys except the drive belt tensioner pulley.

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

    NOTICE:
    1. The backside of the drive belt should face the tensioner pulley.
    2. Check that the drive belt is properly set to each pulley.

  1. G036496E02
    After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.


3. INSTALL ENGINE SERVICE HOLE SUB COVER ASSEMBLY
  1. Install the engine service hole sub cover with the 5 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }


4. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

HINT:
Perform the same procedure as above on the opposite side. (Click here)


5. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

HINT:
Perform the same procedure as above on the opposite side. (Click here)


6. INSTALL FRONT DOOR SCUFF PLATE RH

7. CONNECT NEGATIVE BATTERY CABLE

8. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }


9. PERFORM INITIALIZATION
  1. Some system need initialization when reconnecting the battery cable. (Click here)

← INSTALLATION (Oct 2014 – Mar 2016)COMPONENTS (from Jan 2015) →