2014-2019 Hiace · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL STARTER ARMATURE ASSEMBLY

A071182
Install the starter armature to the starter yoke.

2. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Place the brush holder assembly on the starter yoke.

  1. A102629
    Using a screwdriver, install the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.

  1. A102628
    Install the commutator end frame with the 2 screws.

    Torque:
    3.6 N*m{ 37 kgf*cm , 32 in.*lbf }


3. INSTALL MAGNET STARTER SWITCH ASSEMBLY

  1. A158379E01
    Apply grease to the steel ball and install it onto the starter clutch.

  1. Apply grease to the starter clutch, and install it onto the starter drive housing.

  1. Apply grease to the magnet switch return spring and install it onto the starter clutch.

  1. Apply grease to the clutch roller and install it onto the retainer.

  1. Apply grease to the retainer and install it onto the starter idle pinion.

  1. Apply grease to the starter idle pinion and install it onto the starter drive housing.

  1. A102626
    Install the magnet starter switch with the 3 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY

  1. A102643E01
    Install the felt washer to the starter armature.

  1. Install the starter yoke to the starter switch.

    HINT:
    Align the claw of the starter yoke with the groove of the starter switch.

  1. A115884E01
    Tighten the 2 through bolts.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }

← INSPECTION (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2014) →