Using SST and a hammer, install a new input shaft bearing.
SST
09304-12012
Install 4 new bolts.
Torque:
27 N*m{
276 kgf*cm
, 20 ft.*lbf
}
Mark each bolt with paint as shown in the illustration.
Retighten each bolt by 90°.
Check that the mark on each bolt is at a 90° angle from its original position.
2.
INSTALL CLUTCH DISC ASSEMBLY
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
SST
09301-00110
NOTICE:
Take care not to insert the clutch disc assembly in the wrong direction.
3.
INSTALL CLUTCH COVER ASSEMBLY
Align the matchmark on the clutch cover assembly with the one on the flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts starting from the bolt located near the knock pin on the top.
SST
09301-00110
Torque:
19 N*m{
195 kgf*cm
, 14 ft.*lbf
}
HINT:
Evenly tighten the bolts by following the order shown in the illustration.
Tighten the bolts after checking that the disc is in the center by lightly moving the SST up and down, left and right.
4.
INSPECT AND ADJUST CLUTCH COVER ASSEMBLY
Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.
Maximum non-alignment:
0.9 mm (0.035 in.)
If alignment is not as specified, adjust the diaphragm spring tip alignment using SST.
SST
09333-00013
5.
INSTALL CLUTCH RELEASE FORK BOOT
Install the clutch release fork boot.
6.
INSTALL RELEASE FORK SUPPORT
Install the clutch release fork support to the transmission unit.
Torque:
47 N*m{
479 kgf*cm
, 35 ft.*lbf
}
7.
INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY
Apply Multemp 8158 Grease or equivalent to the release fork, the release bearing assembly, the push rod contact point and pivot points as shown in the illustration.
Grease:
Multemp 8158 Grease or equivalent
Apply clutch spline grease to the input shaft spline.
Sealant:
Toyota Genuine Clutch Spline Grease or equivalent
Install the release bearing to the clutch release fork with the clip.
Install the clutch release fork assembly to the transmission unit.
NOTICE:
After installation, move the fork back and forth to check that the release bearing slides smoothly.