2014-2019 Hiace · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Mar 2016

Versions by build date: Oct 2014 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017


1. INSTALL INPUT SHAFT BEARING

  1. C103898E01
    Using SST and a hammer, install a new input shaft bearing.
    SST
    09304-12012  

    HINT:
    After assembling the input shaft bearing to the hub, make sure that it rotates smoothly.

  1. Install the 2 bolts.

    Torque:
    178 N*m{ 1,815 kgf*cm , 131 ft.*lbf }


2. INSTALL CLUTCH DISC ASSEMBLY

  1. C104159E01
    Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
    SST
    09301-00110  

    NOTICE:
    Take care not to insert the clutch disc assembly in the wrong direction.


3. INSTALL CLUTCH COVER ASSEMBLY

  1. C114265E02
    Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.

  1. Following the procedures shown in the illustration, tighten the 6 bolts starting from the bolt located near the knock pin on the top.

    SST
    09301-00110  

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Evenly tighten the bolts by following the order shown in the illustration.
    2. Tighten the bolts after checking that the disc is in the center by lightly moving the SST up and down, left and right.


4. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

  1. C086210
    Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.

    Maximum non-alignment:
    1.3 mm (0.051 in.)

  1. C114266E01
    If alignment is not as specified, adjust the diaphragm spring tip alignment using SST.
    SST
    09333-00013  


5. INSTALL CLUTCH RELEASE FORK BOOT

  1. C086354
    Install the clutch release fork boot.


6. INSTALL RELEASE FORK SUPPORT

  1. C086353J01
    Install the clutch release fork support to the transmission unit.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }


7. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

  1. C104161
    Apply Multemp 8158 Grease or equivalent to the release fork, the release bearing assembly, the push rod contact point and the pivot points as shown in the illustration.

    Grease:
    Multemp 8158 Grease or equivalent

  1. C103116J02
    Apply clutch spline grease to the input shaft spline.

    Sealant:
    Toyota Genuine Clutch Spline Grease or equivalent

  1. C104155E01
    Install the release bearing to the clutch release fork with the clip.

  1. Install the clutch release fork assembly to the transmission unit.

    NOTICE:
    After installation, move the fork back and forth to check that the release bearing slides smoothly.


8. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY
(Click here)
← INSPECTION (from Oct 2014)INSTALLATION (Apr 2016 – Dec 2016) →