2014-2019 Hiace · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Jan 2015


INSPECT SHIFT SOLENOID VALVE SL1

  1. C197715E07
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    5.0 to 5.6 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve SL1)
    If the value is not as specified, replace the shift solenoid valve SL1.

  1. Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.

    OK:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) with a 21 W bulb → Terminal 1
    2. Battery negative (-) → Terminal 2
    Valve moves and makes an operating noise

    If the operation cannot be done as specified, replace the shift solenoid valve SLT.


INSPECT SHIFT SOLENOID VALVE SL2

HINT:
Refer to Inspect Shift Solenoid Valve SL1.


INSPECT SHIFT SOLENOID VALVE SL3

HINT:
Refer to Inspect Shift Solenoid Valve SL1.


INSPECT SHIFT SOLENOID VALVE SL4

HINT:
Refer to Inspect Shift Solenoid Valve SL1.


INSPECT SHIFT SOLENOID VALVE SLU

HINT:
Refer to Inspect Shift Solenoid Valve SL1.


INSPECT SHIFT SOLENOID VALVE SLT

HINT:
Refer to Inspect Shift Solenoid Valve SL1.


INSPECT SHIFT SOLENOID VALVE SL

  1. C320237E02
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Shift solenoid valve SL connector terminal - Shift solenoid valve SL body
    20°C (68°F)
    11 to 15 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Solenoid Valve SL)
    If the value is not as specified, replace the shift solenoid valve SL.

  1. Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.

    OK:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) → Shift solenoid valve SL connector
    2. Battery negative (-) → Shift solenoid valve SL body
    Valve moves and makes an operating noise

← DISASSEMBLY (from Jan 2015)REASSEMBLY (from Jan 2015) →