2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2015


1. DRAIN AUTOMATIC TRANSMISSION FLUID

  1. C318488
    Remove the drain plug and gasket from the automatic transmission assembly and drain the ATF.

  1. Install a new gasket and the drain plug to the automatic transmission assembly.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

  1. C318505
    Remove the 10 bolts, automatic transmission oil pan sub-assembly and automatic transmission oil pan gasket from the automatic transmission case sub-assembly.

    NOTICE:
    Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all of the bolts, and carefully remove the automatic transmission oil pan sub-assembly.

  1. Remove the 4 transmission oil cleaner magnets from the automatic transmission oil pan sub-assembly.

  1. Examine the particles in the automatic transmission oil pan sub-assembly.

    1. Collect any steel chips with the removed transmission oil cleaner magnets. Carefully inspect the foreign matter and particles in the automatic transmission oil pan sub-assembly and on the transmission oil cleaner magnets to anticipate the type of wear you will find in the automatic transmission assembly.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bush wear


3. DISCONNECT TRANSMISSION WIRE

  1. C318506E01
    Remove the 2 bolts and the 2 temperature sensor clamps, and disconnect the 2 temperature sensors.
    Text in Illustration 
    *1
    Temperature Sensor Clamp
    *2
    Temperature Sensor

  1. Disconnect the 7 solenoid valve connectors and transmission wire from the transmission valve body assembly.

  1. C318507
    Disconnect the transmission wire connector.

    HINT:
    Detach the claw, press down the lever, and disconnect the transmission wire connector.

  1. Remove the bolt and pull out the transmission wire from the automatic transmission case sub-assembly.

  1. C318508
    Remove the O-ring from the connector of transmission wire.

  1. C181076
    Remove the 2 O-rings from the 2 temperature sensors.

← COMPONENTS (from Jan 2015)INSPECTION (from Jan 2015) →