DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built Oct 2014 – Dec 2014
| J-OBD2 |
![]() ![]() |
- When troubleshooting J-OBD2 vehicles, the vehicle must be connected to the intelligent tester. Various data output from the ECM can then be read.
- OBD regulations require that the vehicle's on-board computer illuminates the MIL on the instrument panel when the computer detects a malfunction in:
- The emission control system/components.
- The powertrain control components (which affect vehicle emissions).
- The computer
In addition, the applicable DTCs are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
- When a malfunction is first detected, a DTC is temporarily stored in the ECM memory (1st trip). If the same malfunction is detected during the next subsequent drive cycle, the MIL is illuminated (2nd trip).
| DLC3 (Data Link Connector 3) |
| BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
- If voltage is below 11 V, replace or recharge the battery before proceeding.
| MIL (Malfunction Indicator Lamp) |
The MIL is illuminated when the ignition switch is first turned to ON (the engine is not running).
The MIL should turn off when the engine is started. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.
- HINT:
- If the MIL is not illuminated when the ignition switch is first turned to ON, check the MIL circuit (Click here).
| ALL READINESS |
- HINT:
- With "All Readiness", you can check whether or not the DTC judgment has been completed by using the intelligent tester.
- Check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.
- With "All Readiness", you can check whether or not the DTC judgment has been completed by using the intelligent tester.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and turn the tester on.
Perform the DTC judgment driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input the DTCs to be confirmed.
Check the DTC judgment result.
Intelligent Tester Tester Display
Description
NORMAL
- DTC judgment completed
- System normal
ABNORMAL
- DTC judgment completed
- System abnormal
INCOMPLETE
- DTC judgment not completed
- Perform driving pattern after confirming DTC enabling conditions
N/A
- Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit
- DTC judgment completed

