2014-2019 Hiace · Service Manual ENGINE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

NOTICE:
When the diagnosis system is changed from the normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are erased. Before changing modes, always check and make a note of DTCs and freeze frame data.

HINT:
  1. DTCs which are stored in the ECM can be displayed on the GTS. The GTS can display current and pending DTCs.
  2. Some DTCs are not set if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.


CHECK DTC (Using GTS)
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  5. Check the DTC(s) and freeze frame data, and then write them down.

  6. Check the details of the DTC(s) (Click here).


CLEAR DTC (Using GTS)
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

  5. Press the YES button.


CLEAR DTC (Without using GTS)

  1. Perform either one of the following operations.

    1. Disconnect the negative battery cable for more than 1 minute.

    2. A311410E01
      Remove the EFI NO. 2 fuse from the No. 1 engine room relay block and junction block assembly for more than 1 minute.
      Text in Illustration 
      *1
      No. 1 Engine Room Relay Block and Junction Block Assembly
      *2
      EFI NO. 2 Fuse

← DIAGNOSIS SYSTEM (from Jan 2017)DTC CHECK / CLEAR (Jan 2015 – Nov 2015) →