2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

TERMINALS OF ECU

System information · Vehicles built from Oct 2014


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (except 5L-E)
E103734E01
Terminal No. (Symbols)
Wiring Color
Tester Description
Condition
Specification
H18-2 (PTC2) - H18-29 (GND)*1
LG - W-B
PTC heater control signal
Ignition switch ON
Temperature switch: Max. HOT
Coolant temperature: Below 76°C (169°F)
Ambient temperature: Below 10°C (50°F)
PTC heater: Not operate → Operate (ALT, F-DUTY more than 95%)
Below 1 V → 11 to 14 V
H18-3 (PTC1) - H18-29 (GND)*1
GR - W-B
PTC heater permission signal
Ignition switch ON
Temperature switch: Max. HOT
Coolant temperature: Below 73°C (163°F)
Ambient temperature: Below 10°C (50°F)
PTC heater: Not operate → Operate (ALT, F-DUTY more than 95%)
Below 1 V → 11 to 14 V
H18-4 (PRE) - H18-29 (GND)
R - W-B
Pressure sensor signal
Start engine
Operate air conditioning system
Refrigerant pressure: Abnormal pressure (More than 3,030 kPa (31.0 kgf/cm, 440 psi))
4.7 V or higher
H18-4 (PRE) - H18-29 (GND)
R - W-B
Pressure sensor signal
Start engine
Operate air conditioning system
Refrigerant pressure: Abnormal pressure (less than 180 kPa (1.9 kgf/cm, 27 psi))
Below 0.7 V
H18-4 (PRE) - H18-29 (GND)
R - W-B
Pressure sensor signal
Start engine
Operate air conditioning system
Refrigerant pressure: Normal pressure (less than 3,030 kPa (31.0 kgf/cm, 440 psi) and more than 180 kPa (1.9 kgf/cm, 27 psi))
0.7 to 4.7 V
H18-5 (HEAT) - H18-29 (GND)*5
L - W-B
Idle-up switch signal
Ignition switch ON
Idle-up switch off → ON
11 to 14 V → Below 1 V
H18-5 (HEAT) - H18-29 (GND)*2
L - W-B
Heater switch signal
Ignition switch ON
Heater switch off → ON
11 to 14 V → Below 1 V
H18-6 (HLS) - H18-29 (GND)*1
R - W-B
Headlight dimmer switch signal
Ignition switch ON
Headlight dimmer switch: off → ON
Below 1 V → 11 to 14 V
H18-7 (RCON) - Body ground*3
P - Body ground
Rear blower switch signal
Ignition switch ON
A/C switch off → ON
Below 1 V → 11 to 14 V
H18-8 (A/CS) - H18-29 (GND)
Y - W-B
A/C switch signal
Ignition switch ON
Blower switch ON
A/C switch off → ON
Below 1 V → 11 to 14 V
H18-9 (LED+) - H18-29 (GND)
G - W-B
A/C switch indicator signal
Ignition switch ON
Blower switch ON
A/C switch off → ON
Below 1 V → 11 to 14 V
H18-10 (CANH)
R
CAN communication system
-
-
H18-11 (CANL)
W
CAN communication system
-
-
H18-12 (SG) - Body ground
L - Body ground
Ground for each sensor
Always
Below 1 Ω
H18-13 (S5) - H13-12 (SG)
Y - L
Power supply for pressure sensor
Ignition switch off → ON
Below 1 V → 5.15 V
H18-15 (HTR1) - H18-29 (GND)*2
R - W-B
Heater switch indicator signal
Ignition switch ON
Heater switch off→ ON
Below 1 V → 11 to 14 V
H18-16 (BLW) - H18-29 (GND)
GR - W-B
Blower motor control signal
Ignition switch ON
Blower switch off → ON
11 to 14 V → Below 1 V
H18-17 (HT-2) - Body ground*2
B - Body ground
Magnetic valve signal
Start engine
Operate air conditioning system
Temperature switch: Max. HOT
Coolant temperature: Below 65°C (149°F)
HOT Gas heater: Operate → Not operate
Below 1 V → 11 to 14 V
H18-18 (RMGV) - Body ground*3
Y - Body ground
Rear magnetic valve signal
Ignition switch ON
Rear magnetic valve off → ON
11 to 14 V → Below 1 V
H18-19 (MGC) - Body ground*4
V - Body ground
Magnet clutch ON permission signal
Ignition switch ON
A/C switch off → ON
11 to 14 V → Below 1 V
H18-19 (MGC) - Body ground*6
V - Body ground
Compressor assembly with pulley operation signal
Engine running
Blower switch LO
A/C switch ON
Pulse generation
(See waveform 2)
H18-20 (IG+) - Body ground
R - Body ground
Power source (IG)
Ignition switch off → ON
Below 1 V → 11 to 14 V
H18-21 (PO1) - H18-29 (GND)*7
V - W-B
No. 2 air conditioner pressure sensor signal
Start engine
Operate air conditioning system
Refrigerant pressure: Abnormal pressure (More than 3,030 kPa (31.0 kgf/cm, 440 psi))
4.7 V or higher
H18-21 (PO1) - H18-29 (GND)*7
V - W-B
No. 2 air conditioner pressure sensor signal
Start engine
Operate air conditioning system
Refrigerant pressure: Abnormal pressure (less than 180 kPa (1.9 kgf/cm, 27 psi))
Below 0.7 V
H18-21 (PO1) - H18-29 (GND)*7
V - W-B
No. 2 air conditioner pressure sensor signal
Start engine
Operate air conditioning system
Refrigerant pressure: Normal pressure (less than 3,030 kPa (31.0 kgf/cm, 440 psi) and more than 180 kPa (1.9 kgf/cm, 27 psi))
0.7 to 4.7 V
H18-22 (B/LV) - H18-31 (SG-1)
B - B
Room compartment temperature set signal
Max. HOT → Max. COOL
0 Ω → 3 kΩ
H18-23 (TP2) - H18-30 (SG-2)*3
W - L
Rear evaporator temperature sensor signal
Ignition switch off → ON
Click here
H18-24 (TP) - H18-31 (SG-1)
W - B
Evaporator temperature sensor signal
Ignition switch off → ON
Click here
H18-28 (LOCK) - H18-31 (SG-1)*4
W - B
Compressor lock sensor signal
Engine idling
A/C switch ON (Magnet clutch ON)
Pulse generation
(See waveform 1)
H18-29 (GND) - Body ground
W-B - Body ground
Ground for main power supply
Always
Below 1 Ω
H18-30 (SG-2) - Body ground*3
L - Body ground
Ground for rear evaporator temperature sensor
Always
Below 1 Ω
H18-31 (SG-1) - Body ground
B - Body ground
Ground for each sensor
Always
Below 1 Ω
H18-38 (MH) - Body ground
B - Body ground
Max. hot switch signal
Except max. HOT → Max. HOT
Below 1 V → 11 to 14 V
H18-40 (B) - Body ground
W - Body ground
Power source (Back-up)
Always
11 to 14 V
  1. *1: w/ PTC Heater
  2. *2: w / Heater Switch
  3. *3: w/ Rear Cooler
  4. *4: for 1KD-FTV, 2KD-FTV
  5. *5: w/ Idle-up Switch
  6. *6: for 1TR-FE, 2TR-FE
  7. *7: for LHD, 2TR-FE

  1. I031459E12
    Using an oscilloscope, check waveform.
    Waveform 1 
    Item
    Content
    Terminal No. (Symbol)
    H18-28 (LOCK) - H18-31 (SG-1)*4
    Tool Setting
    200 mV/DIV., 10 msec./DIV.
    Condition
    Engine idling
    A/C switch ON (Magnet clutch ON)

  2. E106664E11
    Using an oscilloscope, check waveform.
    Waveform 2 
    Item
    Content
    Terminal No. (Symbol)
    H18-19 (MGC) - Body ground
    Tool Setting
    5 V/DIV., 500 μs/DIV.
    Condition
    Engine running
    Blower switch LO
    A/C switch on


AIR CONDITIONING AMPLIFIER ASSEMBLY (for 5L-E)
E109942E01
Terminal No. (Symbol)
Wiring Color
Tester Description
Condition
Specification
H19-8 (AC1) - Body ground
B - Body ground
Compressor operation signal
Ignition switch ON
A/C switch: off → ON
3.7 to 4.5 V → 1.3 to 2.6 V
H19-10 (ACT) - Body ground
G - Body ground
Compressor permission signal
Ignition switch ON
A/C switch: off → ON
Below 1 V → 11 to 14 V
H19-11 (A/CS) - H19-6 (GND)
Y - W-B
A/C switch signal
Ignition switch ON
A/C switch: off → ON
Below 1 V → 11 to 14 V
H19-6 (GND) - Body ground
W-B - Body ground
Ground for main power supply
Always
Below 1 Ω
H19-3 (PRS) - Body ground
L - Body ground
Pressure switch signal
Start engine
Operate air conditioning system
Refrigerant pressure: Normally → Less than 0.19 MPa (2.0 kgf/cm, 28 psi) or more than 1.34 MPa (13.7 kgf/cm, 195 psi)
Below 1 V → 11 to 14 V
H19-4 (TE) - H19-16 (SG)
W - B
Evaporator temperature sensor signal
Ignition switch off → ON
Click here
H19-16 (SG) - Body ground
B - Body ground
Ground for each sensor
Always
Below 1 Ω
H19-12 (B/LV) - H19-16 (SG)
B - L-B
Room compartment temperature set signal
Max. HOT → Max. COOL
0 Ω → 3 Ω
H19-7 (TP2) - H19-16 (SG)*
W - B
Rear evaporator temperature sensor signal
Ignition switch off → ON
Click here
H19-18 (RCON) - Body ground*
P - Body ground
Rear blower switch signal
Ignition switch ON
A/C switch: off → ON
Below 1 V → 11 to 14 V
H19-9 (RMGV) - Body ground*
Y - Body ground
Rear magnetic valve signal
Ignition switch ON
Rear magnetic valve: OFF → ON
Below 1 V → 11 to 14 V
H19-15 (MGC) - Body ground
V - Body ground
Magnet clutch ON permission signal
Engine running
A/C switch: off → ON
Below 1 V → 11 to 14 V
H19-13 (IG+) - Body ground
R - Body ground
Power source (IG)
Ignition switch off → ON
Below 1 V → 11 to 14 V
  1. *: w/ Rear Cooler
← PROBLEM SYMPTOMS TABLE (from Jan 2017)DIAGNOSIS SYSTEM (Oct 2014 – Dec 2014) →