2014-2019 Hiace · Service Manual SECURITIES

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Oct 2014

HINT:
  1. When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  2. Refer to the GTS operator's manual for further details.


CHECK FOR IMMOBILISER DTC
  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Entry & Start / Trouble Codes.

  5. Check for DTCs.


CHECK FOR ECM DTC
  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  5. Check for DTCs.


CLEAR IMMOBILISER DTC
  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Entry & Start / Trouble Codes.

  5. Clear the DTCs.


CLEAR ECM DTC
  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  5. Clear the DTCs.

← DIAGNOSIS SYSTEM (from Dec 2017)DATA LIST / ACTIVE TEST (from Oct 2014) →