2014-2019 Hiace · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A122007
    Remove the nut, and then disconnect the lead wire from terminal C.

  1. A122008
    Using a T25 "TORX" socket wrench, remove the 3 screws holding the magnet starter switch to the starter drive housing.

  1. Remove the magnet starter switch.

  1. Remove the return spring.

  1. A122009E02
    Remove the plunger from the pinion drive lever.
    Text in Illustration 
    *1
    Plunger
    *2
    Pinion Drive Lever


2. REMOVE STARTER YOKE ASSEMBLY

  1. A122010
    Remove the 2 bolts and starter yoke from the starter drive housing.

  1. A122011
    Remove the plate from the planet carrier.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A122012
    Hold the starter yoke assembly between aluminum plates in a vise.

    NOTICE:
    Do not damage the starter yoke assembly.

  1. Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.

  1. A122013E03
    Remove the slotted washer.
    Text in Illustration 
    *1
    Slotted Washer

  1. A122014E03
    Remove the washer.
    Text in Illustration 
    *1
    Washer
    *2
    Commutator End Frame

  1. Remove the starter commutator end frame from the starter yoke.

  1. A122015E04
    Remove the starter brush holder from the starter armature.
    Text in Illustration 
    *1
    Rubber Part
    *2
    Brush Holder
    *3
    Spring

    NOTICE:
    Do not pull on the rubber part.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A122016E03
    Remove the starter armature from the starter yoke.
    Text in Illustration 
    *1
    Starter Yoke
    *2
    Starter Armature


5. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A122017
    Remove the 3 planetary gears from the planet carrier.

  1. A122018E03
    Remove the starter center bearing clutch, pinion drive lever and cover from the starter drive housing.
    Text in Illustration 
    *1
    Pinion Drive Lever
    *2
    Cover
    *3
    Starter Drive Housing
    *4
    Starter Center Bearing Clutch

  1. A122019E03
    Using a screwdriver, move the pinion stop collar to the starter clutch.
    Text in Illustration 
    *1
    Collar
    *2
    Clutch

  1. A122020E03
    Using a screwdriver, remove the snap ring.
    Text in Illustration 
    *1
    Snap Ring
    *2
    Collar

  1. A122021
    Remove the pinion stop collar and starter clutch from the planet carrier shaft.


6. REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY

  1. A122022
    Using 2 screwdrivers and a hammer, tap off the snap ring from the planet carrier shaft.

  1. Remove the washer from the planet carrier shaft.

  1. A122023E03
    Remove the planet carrier shaft from the planet carrier.
    Text in Illustration 
    *1
    Planet Carrier
    *2
    Planet Carrier Shaft

  1. Remove the intermediate sealing and the 3 damper rubbers from the planet carrier.

← REMOVAL (from Jan 2017)INSPECTION (from Oct 2014) →