2014-2019 Hiace · Service Manual ENGINE

INITIALIZATION

Troubleshooting · Vehicles built from Jan 2017


INITIALIZATION PROCEDURE FOR DIESEL THROTTLE BODY ASSEMBLY, ELECTRIC EGR CONTROL VALVE ASSEMBLY AND TURBOCHARGER NOZZLE VANE CONTROL ACTUATOR

HINT:
When the diesel throttle body assembly, electric EGR control valve assembly or turbocharger nozzle vane control actuator is replaced, perform initialization

  1. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  2. Turn the ignition switch off and wait for 30 seconds or more.

  3. Turn the ignition switch to ON and wait for 10 seconds or more.


CATALYST RECORD OF DPF THERMAL DETERIORATION CLEAR FUNCTION

HINT:
When the exhaust manifold converter sub-assembly is replaced, the catalyst record of DPF thermal deterioration stored in the ECM must be cleared.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the menu options in this order: Powertrain / Engine and ECT / Utility / Catalyst Record Clear.

  5. Press "Next".

  6. Press "Exit".

  7. Enter the menu options in this order: Powertrain / Engine and ECT / Utility / DPF Deterioration Record Clear.

  8. Press "Next".

  9. Press "Exit".


CRANK TIME COMPENSATION RESET FUNCTION
  1. This procedure uses the GTS to perform "Crank Time Compensation Reset".
  2. When replacing the crankshaft, perform "Crank Time Compensation Reset".

HINT:

  1. A204035
    If an error occurs during compensation reset, check the vehicle condition, and then perform compensation reset again.
  2. A communication malfunction may occur if there is a problem with the ECM, a wire harness or the connection to the DLC3. If the wire harnesses and the connection to the DLC3 are inspected and found to be normal, the ECM may be malfunctioning.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / Utility / Crank Time Compensation Reset.

  5. A280989
    When the first screen is displayed, check the vehicle condition and push "Next".

  6. A280984
    When the screen indicating reset completion is displayed, push "Exit".


A/F SENSOR COMPENSATION RESET FUNCTION
  1. This procedure uses the GTS to perform "A/F Sensor Compensation Reset".
  2. When replacing the air fuel ratio sensor, replace the sensor and then perform "A/F Sensor Compensation Reset".

HINT:

  1. A204038
    If an error occurs during compensation reset, check the vehicle condition, and then perform compensation reset again.
  2. A communication malfunction may occur if there is a problem with the ECM, a wire harness or the connection to the DLC3. If the wire harnesses and the connection to the DLC3 are inspected and found to be normal, the ECM may be malfunctioning.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / Utility / A/F Sensor Compensation Reset.

  5. A320567
    When the first screen is displayed, check the vehicle condition and push "Next".

  6. A320568
    When the screen indicating reset completion is displayed, push "Exit".

← REGISTRATION (from Jan 2017)PROBLEM SYMPTOMS TABLE (from Jan 2017) →